![]() By how much, you ask? Start by adjusting by 0.1mm in the appropriate direction.and reprint. Note the value can go negative!! To increase the nozzle height, adjust the value in a positive direction. To move the nozzle closer to the bed, adjust the value in a negative direction. To adjust the nozzle height above the bed, use the Global-Z setting on the GCode tab. Level it once.and leave it alone!! If the bed is level.ie the same item prints anywhere on the bed with the same result for the first layer or two.use settings in S3D to tweak the height of the nozzle to get it spot on! If you have an "elephants foot" effect.then your nozzle is too close to the bed. I have a bunch of face down embossed text to print and the text is not readable with the squishing on layer one that happening.įirst of all.repeatable levelling of the bed is wasting time and effort. The rest is pretty much stock from the ABS material and manufacture recommendations.Īny help would be greatly appreciated as this is massively holding up my prints. I am using a 20x20x20 cube for test print (this could mean a less than 2sec print per layer ? Print speed: 4200 (have tried from 3600-4800)Īdjust print speed for layers below 2 secs, 10% (have not tried changing this, now that i read it) Z axis: -.08 (have leveled the bed 20 times over the last few days) No additions (I usually use brim but turned it off to see if it helped, no diffrence) Outline direction: inside out (i have tried both) Outline/Perim: 3 (the outside other than the first few layers look very good for. Retraction: 6mm, Ex:-.2,vert:0, Speed:1800 no cost, no wipe 75)Įxtrusion width: Auto (I have tried down to. Speed: 4200mm/min (ive tried down to 3600)Įxtrusion multiplier. General settings at the moment (i have tried many recommendations) Software: Simplif圓D and octp print (I have tried printing directly via usb same problem)įilament: 1.75, ApolloX, white and natural (both do the same thing) Printer: CR-10s (I have two of them they are both doing the same thing)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |